Product Details
Share :
Providing consultation on construction material selection and usage
Free assistance from our staff for usage support
Track Your Package
- For plastering on lightweight block
- The first plastering mortar in Thailand
- Good bonding strength and reduced cracks thanks to special fibers added
- Soft and smooth texture, easy to plaster without much effort
- Longer cure time
- Contain water retention agent preventing water loss
- Smoother plastered surface due to fine sand
- Can be used with a plastering mortar sprayer
- Suitable for both indoor and outdoor applications
Techniques for Plastering Lightweight Concrete Block Walls
-
Plaster thickness up to 1.5 cm:
You can plaster directly to the desired thickness. First, press and smooth a thin layer of plaster with a trowel, then add more plaster to reach the required thickness. -
Plaster thickness between 1.5 and 2.5 cm:
Apply plaster to a thickness of 1–1.5 cm and wait until it sets to a damp stage. Then add the remaining plaster to reach the desired thickness and wait for it to set again. (Do not make the plaster too watery, as this may cause sagging.) -
Plaster thickness exceeding 2.5 cm:
Cracking may occur later. It is recommended to install #125 wire mesh fully over the areas with thick plaster before applying the plaster layers. -
When the plaster has set to a firm damp state, you can use a triangular trowel to level the surface, then fill in any low spots, level again, and finally do the finishing plaster work as needed.
-
After finishing the plaster, when it starts to set but is still damp and firm, you can spray water with a brush to create a smooth, bubbly surface texture immediately. After spraying water, it is recommended to brush the surface to achieve a smooth and beautiful finish.
This is a two-component chemical adhesive (epoxy acrylate type) made from methacrylate, free from carcinogenic substances, ideal for anchoring deformed rebar and threaded rods, offering easy application and cost-effective performance.
This high-performance, polymer-modified hybrid sealant offers exceptional adhesion, is mold-resistant, rust-inhibiting, and moisture-tolerant, with an acid-free, odorless, and bubble-free formula that is paintable, fills gaps completely, dries to a smooth, non-sag finish, and remains highly flexible to accommodate structural movement and vibration.
